I came across this old handle clearing out a drawer. It is a d-shaped Cocobolo/ebony handle that I made for a 210 moritaka petty. As an oops, I made it close to the original size, but the owner wanted a slightly larger handle. It was once attached, then removed. I think it’s in fine shape, but due to the circumstances, I would not sell it.
The cost is essentially shipping for anyone who wants it, probably $5-10. Depending on what you put into it, the next owner may need to clean out the epoxy inside. Theoretically, it should fit a 210 moritaka petty.
Clean it up and you have a fine petty handle.
Comment below if you want it.
TAKEN - Project handle - removed from knife
TAKEN - Project handle - removed from knife
Last edited by jobone on Sat Jan 25, 2020 7:43 am, edited 2 times in total.
Instagram : jobone_craftsman
https://www.instagram.com/jobone_craftsman/
Etsy : https://www.etsy.com/shop/JoBoneCraftsman
https://www.instagram.com/jobone_craftsman/
Etsy : https://www.etsy.com/shop/JoBoneCraftsman
-
- Posts: 69
- Joined: Mon Nov 18, 2019 11:52 am
- Has thanked: 12 times
- Been thanked: 1 time
Re: Project handle - removed from knife
This is a cool handle, if it hasn't been claimed yet I would love to see what I can put it on please
Thanks!
Thanks!
Re: Project handle - removed from knife
DM sentBanzai_Burrito wrote: ↑Fri Jan 24, 2020 3:05 pm This is a cool handle, if it hasn't been claimed yet I would love to see what I can put it on please
Thanks!
Instagram : jobone_craftsman
https://www.instagram.com/jobone_craftsman/
Etsy : https://www.etsy.com/shop/JoBoneCraftsman
https://www.instagram.com/jobone_craftsman/
Etsy : https://www.etsy.com/shop/JoBoneCraftsman