I purchased this ittosai 210mm gyuto (ryusen OEM?) knife about 10 years ago. I like the don't like its performance. It's never seen heavy duty and have sharpened it though full progressions of 800/2k/6k about 4 times. It seems to wedge hard vegetables a lot and struggles with food release. Are there certain tasks that a knife with this grind would be better at or should I try to thin it out.
[URLtarget][/URLtarget]
Reprofile knife or leave as is?
-
- Posts: 4988
- Joined: Wed Jan 25, 2017 2:54 pm
- Location: CT
- Has thanked: 30 times
- Been thanked: 1198 times
Re: Reprofile knife or leave as is?
Most knives like that have fairly flat grinds to them (less convexing) and may have thicker edges. I would try thinning it out the edge and see how it does.
Hard veggies are hard for most knives to cut. I find they cut easier with a pushing down and away motion instead of trying a straight chop as well as using a 240mm or longer vs a 210mm since the short length limits the amount you can push forward and down. Convexing helps, but will push the food away and may end up cracking the food if it's a thicker blade. Hard veggies are hard to cut with most knives.
Hard veggies are hard for most knives to cut. I find they cut easier with a pushing down and away motion instead of trying a straight chop as well as using a 240mm or longer vs a 210mm since the short length limits the amount you can push forward and down. Convexing helps, but will push the food away and may end up cracking the food if it's a thicker blade. Hard veggies are hard to cut with most knives.
Re: Reprofile knife or leave as is?
Thanks for the suggestion. I'll try to think out the edge and see how it goes.