Something in the works.
Moderator: Bensbites
-
- Posts: 2598
- Joined: Mon Jan 30, 2017 7:42 pm
- Location: Massachusetts
- Has thanked: 346 times
- Been thanked: 256 times
- Contact:
Something in the works.
One of these two blades will be for a 220 mm ktip tall magnacut gyuto passaround.
-
- Posts: 2598
- Joined: Mon Jan 30, 2017 7:42 pm
- Location: Massachusetts
- Has thanked: 346 times
- Been thanked: 256 times
- Contact:
Re: Something in the works.
Heat treated in house and tested the hardness to be 61.5-62 hrc on this magnacut.
-
- Posts: 2598
- Joined: Mon Jan 30, 2017 7:42 pm
- Location: Massachusetts
- Has thanked: 346 times
- Been thanked: 256 times
- Contact:
Re: Something in the works.
I am almost done on the course belts. Then onto refunding the scratch patters, convexing the edge and adding the hollow for the s- grind. Based on my grinding, magnacut is very wear resistant.
-
- Posts: 4988
- Joined: Wed Jan 25, 2017 2:54 pm
- Location: CT
- Has thanked: 30 times
- Been thanked: 1198 times
-
- Posts: 2598
- Joined: Mon Jan 30, 2017 7:42 pm
- Location: Massachusetts
- Has thanked: 346 times
- Been thanked: 256 times
- Contact:
Re: Something in the works.
Ok. I have taken this to roughly 400 grit, but there are still course scratches. I am about to test cut before I finish the blades. ~55x220 mm enjoy!
-
- Posts: 4988
- Joined: Wed Jan 25, 2017 2:54 pm
- Location: CT
- Has thanked: 30 times
- Been thanked: 1198 times